Have a set of standard Main bearings for a SBC. Actually 2 sets. One is Clevite H Series and the other is summit brand(low end King bearings). Never ran, just used for fit check and then took them back out in favor of .001 over size.
40 bucks.
Have a set of Comp 7.2" long single piece 5/16" pushrods for SBC> Same length as factory roller block takes. 25 bucks takes them or whatever I said on FB. Too lazy to go look. Also have a spare poly torque arm mount, free...
Set of 3.73 gears for 10 bolt 7.5". New in styrofoam. 75 bucks...
I think thats about it...oh, have set of Comp R Lifters..roller. 75 bucks...need to be sent in for rebuild. Bearing or two fed through them...but have less than 2k miles on them. Could try flushing...up to you.
Send me a message if interested.